VRIJLOOPLAGER ASNU17 STIEBER

Product description:

• Type ASNU is a roller type freewheel non-bearing supported
• Bearings are required to support axial and radial loads
• Lubrication and sealing must also be provided by the installation
• Nominal outer diameter is the same as a series 63 ball bearing
• A typical arrangement is to install this type alongside a bearing within the same location tolerances, as shown on the following page
• The inner race is keyed to the shaft
• The outer race has positive n6 tolerance, to give a press fit in a H7 housing
• Additional side notches in the outer race provide for positive torque transmission
• If the housing is to K6 tolerance, use of the notches is not necessary, but the housing must be strong enough to not expand after assembly
• This design can accept an axial misalignment of inner and outer race of ± S/2