VRIJLOOPLAGER AE12 STIEBER

Product description:

• Type AE is a roller type freewheel non-bearing supported
• Bearings are required to support axial and radial loads
• Lubrication and sealing must also be provided by the installation
• Nominal outside diameter is a standard ball bearing dimension
• A typical arrangement is to install this type beside a bearing with the same housing diameter tolerance as shown on the following page
• The inner race is keyed to the shaft
• The outer race has a h6 tolerance and should be fitted in a housing with a K7 tolerance
• Additional side notches provide for positive torque transmission
• If the housing tolerance is to R6, use of the notches is not necessary, but the housing must be strong enough to not expand after assembly
• This design can accept an axial misalignment of inner and outer race of ± S/2