TEC7 - Anchor - chemical anchor - 280 ml - 02647286

Product description

CHEMICAL ANCHOR

• For concrete, solid and hollow stone
• Free of styrene and phthalates
• Also under water
• From -10°C
• Anchor is a 2-component chemical anchor based on styrene-free vinylester resins in a standard pattern, sprayable with a Tec Gun
• The mixing of the two components is achieved by using static mixing tips
• The unique combination of fast curing, wide application margins and physical properties make it a unique chemical anchor in the professional market
• For effective fixing and assembly in all building materials, such as concrete, solid and hollow brick, aerated concrete, etc.
• Anchor withstands high forces and can be used on wet surfaces, even under water,
• at temperatures from -10°C to +40°C. After fast curing, Anchor is stronger than the substrate:
• Without shrinkage, thus reliable and without expansion, thus low stress
• Safe, environmentally friendly and user-friendly
• Can also be used indoors: styrene-free, phthalate-free, low-odour
• Due to its exceptionally high UV and chemical resistance, even against chlorinated and salt water, Anchor can be used in aggressive environments
• Anchor is dimensionally stable and can also be used overhead in holes in the ceiling Very long shelf life, even if the tube is opened and used

Instructions

• Drill a hole with the correct diameter (see diagram)
• Remove dust from the drill hole with a brush, pump or compressed air
• Place Anchor in a Tec Gun, open the cartridge at the top with a knife and attach the mixer tip
• Spray out about 10 cm to mix the two components correctly
• For solid brick: fill the borehole from back to front
• For hollow stone: use a Harpoon plug and fill it with Anchor
• Insert the threaded rod with a twisting motion
• Remove any excess product
• Anchor can be used in temperatures down to -10°C, as long as the cartridge is at room temperature (+15°C)
• The cartridge can be stored after use sealed with the protective screw cap