MS-POLYMEER GRIJS TEC7 - 400ML TEC 7

Product description

SEAL, BOND AND ASSEMBLE EVERYTHING

• Unique adhesion to almost all materials
• Very high bonding strength
• Fast strength build-up
• Cures up to -10°C
• Highest class in mould resistance
• Unique adhesion on difficult materials
• On dry and wet substrates
• Permanently elastic over the long term
• Highly UV-resistant and colourfast for indoor and outdoor use
• Safe on mirrors and insulation materials, no marking on natural stone
• Free of isocyanates, solvents and phthalates
• Water- and airtight

Instructions

• Processing temperature between -10°C and +40°C. At temperatures below 0°C, curing will be greatly delayed
• Apply on clean, stable, dust- and grease-free substrates
• Use Tec7 Prepare & Finish for safe cleaning and a perfect finish
• In case of heavy soiling, clean with Tec7 Cleaner and/or Multiclean
• Test the adhesion on plastics, powder paints, exotic types of wood and bituminous materials
• Reinforce weak and/or porous substrates first with Poxy Primer
• PT7 primer ensures optimal adhesion to difficult (LSE) plastics and powder coatings
• Tec7 cures through a reaction with (air) moisture
• Use Tec7 in lines, not in thick dots. Dots will cure much more slowly
• When used between two airtight materials, it is recommended to moisten one of the surfaces very slightly
• Use vertical glue strips to avoid moisture and dust accumulation
• Ideal adhesive thickness: 0.5 mm to 3 mm
• Thinner layers = higher strength, Thicker layers = higher elasticity
• Paintable after skin formation
• Do not use with alkyd-based lacquers and paints
• Use Tec7 Cleaner and/or Tec7 Powerwipes for cleaning tools and/or removing uncured Tec7. Clean hands and skin with Tec7 Powerwipes. Cured Tec7 can only be removed by mechanical means. The last residues can be removed with Remove All if the substrate can withstand it.