To correct deformed furniture doorsCan also be used preventively against door warpingFor door/front panel thicknesses from 16 mmMaximum door/front panel height 2600 mmProcessing is simple and problem-free: one right-hand or left-hand threaded rod each is inserted into a clamping sleeveIn addition, the threaded rods each lie in a housing that is inserted and screwed into a 35 mm boreBy turning the clamping sleeve, a tensile or compressive stress is achieved and thus hollow or round doors are readjustedBy covering housing, tension sleeve and threaded rods, wardrobe and linen are guaranteed not to be damagedThe adjustment fitting can also be used horizontallyWe recommend using 2 vertical adjustment fittings near the outer edge. For large, wide doors, 2 additional horizontal adjustment fittings can be used instead 